AutoCAD Raster Design General Discussion

AutoCAD Raster Design General Discussion

Reply
New Member
jhurt
Posts: 1
Registered: ‎02-04-2010
Message 1 of 1 (126 Views)

Is there anyway to make the rubbersheeting run faster

126 Views, 0 Replies
02-04-2010 07:42 AM
At work we rubbersheet a lot of images. The images very in sizes. Some run great and are good on the time it takes to run, while other take a long time. There seem to be no rhyme or reason to which on will run fast. Most small images run fine, some not so much. When running the polynomial the time seem fine, it's when I run the triangular that it slow down. All images are inserted, a grid is added and then point are put in. There could be as little as 10 points or as many as 200. It doesn't seem to make a difference in which ones will run slow.

Does anyone have any helpful hints that I could try?
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Raster Design Category!

The AutoCAD Raster Design forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.