AutoCAD Raster Design General Discussion

AutoCAD Raster Design General Discussion

Reply
New Member
1 Posts
0 Kudos
Registered: ‎11-12-2008
Post 1 of 1

Follower Line Smoothness

338 Views, 0 Replies
06-02-2010 09:22 AM
Hi,
I am a very new user to AutoCad and Raster design. I have Map 3D 2010 and Raster Design 2010 and have been asked to vectorize some bathymetry lines. I have been experimenting with the Polyline and Contour follower and can get the lines to vectorize. The problem, however, is that they are very jagged. A curved section has very few nodes/vertices used to define it so instead of a smooth curve I am getting a jagged curve.

Is there a way to increase the smoothness of a vectorized line? Can I increase the frequency that Raster Design uses to vectorize a line?

Thanks in advance,

Charlie.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Raster Design Category!

The AutoCAD Raster Design forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.