AutoCAD Raster Design General Discussion

AutoCAD Raster Design General Discussion

Valued Contributor
Posts: 69
Registered: ‎03-02-2004
Message 1 of 1 (918 Views)

Exporting GeoTIFF

918 Views, 0 Replies
06-23-2011 02:05 PM

I want to improve the accuracy on an existing scanned image to match data that has been updated so that I can add it to our GIS.  I import the legacy map as a TIFF file, rubbersheet it to lines that I created using AutoCAD Map which has a projection assigned and then export if as a GeoTIFF.  This should be pretty straightforward, but I have a couple of problems.


  1. When I use the polynomial method of rubbersheeting the raster data is adjusted inconsistently and, while the image is improved, the lines are not moved to the proper location.  However, I can export it as a geotiff and the image comes in at the correct location in the GIS.
  2. When I use the triangular method the raster data is pulled into the correct location, but  the geotiff comes in smaller than the target area.  It's as if the data were scaled somewhere in the transfomation.

How do I reconcile this problem?


Is there a way to improve the polynomial rubbersheeting to give me what I want?

What's up with the image size created by the triangular rubbersheeting?




J Edward Leavitt

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Raster Design Category!

The AutoCAD Raster Design forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.