AutoCAD R12/R13/R14 Archive

AutoCAD R12/R13/R14 Archive

Reply
New Member
angelo
Posts: 1
Registered: ‎12-19-2004
Message 1 of 2 (573 Views)

Error in APPID Table on line 404 when opening a .DXF

573 Views, 1 Replies
12-19-2004 10:02 AM
We cannot import a .dxf file into Autocad R14. We use Windows 98SE. We do File>Open, click on the file with extension .dxf and the error shown in the subject line comes up. Then it says "Invalid or incomplete DXF input -- drawing discarded." The DXF file is generated from electronics s/w Protel 98SE.

Thank you,
Angelo Pietroforte
angelo@forte-vision.com
(408) 934-5881
*R.K. McSwain
Message 2 of 2 (573 Views)

Re: Error in APPID Table on line 404 when opening a .DXF

12-20-2004 06:25 PM in reply to: angelo
On 12/19/2004 12:02 PM angelo@forte-vision.co wrote: > We cannot import a .dxf file into Autocad R14. We use Windows 98SE. > We do File>Open, click on the file with extension .dxf and the error > shown in the subject line comes up. Then it says "Invalid or > incomplete DXF input -- drawing discarded." The DXF file is > generated from electronics s/w Protel 98SE. Sounds like you need to take this problem up with the makers of "electronics s/w Protel 98SE".
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.