AutoCAD Plant 3D General DIscussion

AutoCAD Plant 3D General DIscussion

Reply
New Member
CWarne
Posts: 2
Registered: ‎04-02-2014
Message 1 of 5 (152 Views)

Water Droplet Doesn't Disapper with Iso Message

152 Views, 4 Replies
04-02-2014 09:53 AM

The disconnect water droplet does not disappear when an iso message is placed at the node. Software version is Plant 3D 2014. Any suggestions?

 

Thanks,

 

Chris

Mentor
EricNyh
Posts: 179
Registered: ‎03-31-2009
Message 2 of 5 (136 Views)

Re: Water Droplet Doesn't Disapper with Iso Message

04-02-2014 11:34 AM in reply to: CWarne

This drives me crazy when the iso message attaches to the node rather than the piping component.  I have no solutions but would like an answer/fix as well.

*Expert Elite*
patpat79
Posts: 230
Registered: ‎03-13-2014
Message 3 of 5 (124 Views)

Re: Water Droplet Doesn't Disapper with Iso Message

04-02-2014 07:38 PM in reply to: CWarne

so you want the droplets (visual sign of disconnected piping) to disappear if an iso message is placed?? I know that what 2012/2013 version behaves and we do not want that for it will cause confusion.

Best Regards,
Pat Andres
Autodesk Expert Elite
CAD System Engineer
Freelancer
image001.png


 


 


 


 


 

*Expert Elite*
patpat79
Posts: 230
Registered: ‎03-13-2014
Message 4 of 5 (123 Views)

Re: Water Droplet Doesn't Disapper with Iso Message

04-02-2014 07:40 PM in reply to: EricNyh

have you tried using nearest for snap??

Best Regards,
Pat Andres
Autodesk Expert Elite
CAD System Engineer
Freelancer
image001.png


 


 


 


 


 

Mentor
EricNyh
Posts: 179
Registered: ‎03-31-2009
Message 5 of 5 (109 Views)

Re: Water Droplet Doesn't Disapper with Iso Message

04-03-2014 06:58 AM in reply to: patpat79

Say you have a flanged valve with flanges on either side.  One flange is existing.  If you place an iso message on the valve near the existing flange, where your tie-in will be located, the red sphere will jump to the node location.  Eventually, it seems, the iso sphere will "join" with the valve and leave the flange disconnected. 

 

What you end up doing is deleting the iso message, rejoining the flange/valve combination and then recreating the iso message.

 

It's a pain.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Plant 3D Category!

The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!