AutoCAD Plant 3D General DIscussion

AutoCAD Plant 3D General DIscussion

Reply
Member
johanviro
Posts: 5
Registered: ‎03-04-2013
Message 1 of 2 (216 Views)

wafertype butterfly, lined, without gaskets

216 Views, 1 Replies
03-15-2013 04:09 AM

Hello Jason.drew and/or rchiasson,

 

This is a follow -up of an earlier post from 03-04-2013 03:07 AM.

 

I've done all commands exactly as shown in video http://www.screencast.com/t/ZsTFiXbaqd

but there are some mistakes in it, look at attachment.

 

A weld is created at the facing of one of the flanges, and the length of the bolting is not correct: the length of the butterfly is not included.

 

Could you please advise ?

regards,

 

johanviro

Active Member
no1land
Posts: 9
Registered: ‎10-20-2010
Message 2 of 2 (85 Views)

Re: wafertype butterfly, lined, without gaskets

11-21-2013 07:06 AM in reply to: johanviro

I'm getting the same thing, but my bolts looks ok.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Plant 3D Category!

The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.