AutoCAD Plant 3D General DIscussion

AutoCAD Plant 3D General DIscussion

Reply
Active Member
dustyray
Posts: 10
Registered: ‎02-14-2011
Message 1 of 2 (132 Views)

Valve to valve ?

132 Views, 1 Replies
02-01-2013 03:31 AM

Is it possible to place a check valve against a gate valve in the 3D model ? If so, how to keep from getting double bolt set and gaskets ?

*Expert Elite*
dave.wolfe
Posts: 733
Registered: ‎12-04-2009
Message 2 of 2 (122 Views)

Re: Valve to valve ?

02-01-2013 05:36 AM in reply to: dustyray

Yes just drag the second valve over the end of the first.  To do it while routing, type F for fitting and the F for flange to flange after selecting the second valve.

Dave Wolfe
Isaiah 57:15

ECAD, Inc.
Tips and Tricks on our blog: Process Design, from the Outside

A P3D Authorized Reseller
Plant 3d Wish list: https://plant3d.uservoice.com/
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Plant 3D Category!

The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.