AutoCAD Plant 3D General DIscussion

AutoCAD Plant 3D General DIscussion

Reply
Active Member
dmitzel2003
Posts: 7
Registered: ‎11-16-2012
Message 1 of 2 (221 Views)

Trying to access "properties" palette, ACAD Plant says its "unknown command"

221 Views, 1 Replies
11-16-2012 11:09 AM

When I try to use the "properties" palette, ACAD Plant says its "unknown command".  It also says this for the qui kcalculator, design center, quick properties.  I go and modify my cui/workspace setup and save it after I know it looks correct.  Then the next time I restart ACAD Plant, the same palettes are off, and I have to do the same thing all over again.

 

Does anyone know what the problem may be?

Valued Mentor
Rich.O.3d
Posts: 526
Registered: ‎08-19-2008
Message 2 of 2 (171 Views)

Re: Trying to access "properties" palette, ACAD Plant says its "u

11-19-2012 02:26 PM in reply to: dmitzel2003

have your tried doing a repair on plant3d from control panel/programs

CAD Management 101:
You can do it your own way,
If its done just how I say!
[Metallica:And Justice For All:1988]
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Plant 3D Category!

The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.