When I use my Osnaps, I use shift+right click, then use a single hot key (as underlined when the menu opens).
Since installing SP1 for 2013, I can only use the hot key once (after a short while I can use a hot key once again), next time I try to use a hot key, it just closes the menu and redirects the key entry into the command prompt.
Any thoughts on what is going on here? BTW, this does seem to be just in Autocad/ plant as excel still "hot keys" normally.
Solved! Go to Solution.
Solved! by robertstroz8845. See the answer in context.
Looks like the latest SP1.1 for x64 win7 has fixed this issue; although, I did not notice it mentioned within the readme.
Could you provide the details of the hot key issue you experieced with AutoCAD 2013 SP1? You can contact me via my email - email@example.com directly.
AutoCAD Test Development
You are correct, this issue also effects using Osnaps in Plant3d (and apparently all other verticals based upon AutoCAD 2013 for which SP1 was installed upon). I posted it here since my Suite of products are under the Plant design ultimate suite.
I have found others with this problem:
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions to get help installing your software.
The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.
Upgrading to a 2015 product? Make sure to check these out 1st!