AutoCAD Plant 3D General DIscussion

AutoCAD Plant 3D General DIscussion

Reply
*Patrick
Message 1 of 2 (198 Views)

Sloping pipework

198 Views, 1 Replies
03-31-2010 04:19 AM
How does Plant 3D handle sloping pipework. Angles can vary from a few
degrees to 90 degrees.
Employee
gulnacm
Posts: 74
Registered: ‎08-08-2008
Message 2 of 2 (198 Views)

Re: Sloping pipework

03-31-2010 06:20 AM in reply to: *Patrick

You can slope pipe 2 ways prior to routing you can activate the slope panel on the 3D Piping Home Ribbon this will slope horizontal pipe per the specified ratio.

The second can also slope pipe after it has been already routed by using the command PLANTPIPESLOPE. This will allow you to slope a selected route with multiple segments and enter a common slope. Choose the starting pipe segment then the last pipe segment even if its across multiple piping fittings and other pipe segments.

Mike G (Autodesk)



Michael Gulnac
Technical Specialist
Organization
Autodesk, Inc.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Plant 3D Category!

The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.