AutoCAD Plant 3D General DIscussion

AutoCAD Plant 3D General DIscussion

Active Member
7 Posts
0 Kudos
Registered: ‎12-03-2009
Post 1 of 2

Retain Isometric Annotations

196 Views, 1 Replies
02-23-2010 07:38 PM
If I create an isometric drawing and add an annotation to the face of it, it gets removed if I have to run the iso again. There are lots of circumstances that annotations need to be retained is this possible in Plant 3D? I know it can be done in other programs that use isogen.
74 Posts
0 Kudos
Registered: ‎08-08-2008
Post 2 of 2

Re: Retain Isometric Annotations

02-25-2010 02:36 PM in reply to: t-mcconnell
currently our isogen generation does not retain any information from previouse iso's. It will overwrite the file if the option is checked or create the same file with an alpha designator ie 100 and 100A.

You can add annitations and notes to the model on the Iso ribbon tab with Isogen Messages and Isogen Info functions. These will then be transfered to the isometric drawing

Mike G

Michael Gulnac
Technical Specialist
Autodesk, Inc.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Plant 3D Category!

The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Are you interested in helping shape the future of the Autodesk Community? To participate in this brief usability study, please click here. Your time and input is greatly appreciated!