AutoCAD Plant 3D General DIscussion

AutoCAD Plant 3D General DIscussion

Reply
Active Contributor
ashley.walker
Posts: 36
Registered: ‎10-10-2011
Message 1 of 4 (250 Views)
Accepted Solution

Project Number as Document/Drawing Number

250 Views, 3 Replies
09-17-2012 11:18 PM

Hello everyone.

 

This has been baffling me for quite a while.... We have a requirement to have out document names the conatin the project number. I have attached 2 images showing where we type in the project number (whilst setting up the project) and where I would like to be able to pull it into (on creation of a new drawing).

 

I have attempted to create an acusition property and pull it in. But it seems that the file name cannot contain any 'aqusition properties'.....

Does anyonw know of a work aruound or a solutions (I'm not really wanting to type the number in everytime when I create a new drawing).

Any solutions welcome.

I was going to suggest similar to what you had already done. Create a new pulldown list (which unfortunately won't be an acquisition) which has the project number already listed, so when you create a new drawing, there is a pulldown for the project number, and its the only entry.

Employee
TomislavGolubovic
Posts: 553
Registered: ‎12-01-2010
Message 2 of 4 (232 Views)

Re: Project Number as Document/Drawing Number

09-18-2012 01:09 PM in reply to: ashley.walker

I was going to suggest similar to what you had already done. Create a new pulldown list (which unfortunately won't be an acquisition) which has the project number already listed, so when you create a new drawing, there is a pulldown for the project number, and its the only entry.



Tomislav Golubovic
Plant Solutions Engineer
Autodesk Australia / New Zealand
Autodesk, Inc.

Active Contributor
ashley.walker
Posts: 36
Registered: ‎10-10-2011
Message 3 of 4 (226 Views)

Re: Project Number as Document/Drawing Number

09-18-2012 03:56 PM in reply to: TomislavGolubovic

That is pretty much the conclusion that I had also come to.

 

Thank you.

Active Member
ae_m44
Posts: 9
Registered: ‎07-18-2012
Message 4 of 4 (19 Views)

Re: Project Number as Document/Drawing Number

12-07-2014 11:53 PM in reply to: ashley.walker
how to add a new pull down list?
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Plant 3D Category!

The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.