AutoCAD Plant 3D General DIscussion

AutoCAD Plant 3D General DIscussion

Reply
Mentor
TRdesigner82
Posts: 188
Registered: ‎08-16-2012
Message 1 of 2 (216 Views)

Piping connected to Xref nozzle

216 Views, 1 Replies
08-21-2012 07:07 AM

I've noticed that if you have piping connected to a nozzle and both are in the same dwg, the piping will change sizes and update automatically when the nozzle size changes. However, if the nozzle size changes and it's on a piece of equipment that is in an Xref inside of the piping dwg, the piping wont update. Is there a way to get the piping to update automatically. I don't know if there is some setting that needs set on the Xref or what???

 

Thanks,

Employee
lopezjo
Posts: 102
Registered: ‎07-26-2007
Message 2 of 2 (181 Views)

Re: Piping connected to Xref nozzle

08-22-2012 02:46 PM in reply to: TRdesigner82

Propagation of changes does not cross drawing boundaries. Are you editing the XREF'ed DWG while having the host drawing also opened?



Jorge Lopez
Software Architect
Autodesk Plant Solutions
Autodesk, Inc.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Plant 3D Category!

The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.