The pipe supports do not rotate and align to the pipe when I have a Sloped Pipe. Is it possible to change any settings in the program to make the pipe supports align with the pipe slope?
I have the same problems. But you can rotate the support after attaching it to a pipe. this is what i have been doing on my sloep pipes. after you have rotated a support you just copy that one to youre next location using array with slope after pipe. remember to use Reference when you rotate the support sp you get it exactly right on the pipe
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions to get help installing your software.
The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.
Upgrading to a 2015 product? Make sure to check these out 1st!