AutoCAD Plant 3D General DIscussion

AutoCAD Plant 3D General DIscussion

Reply
New Member
Stefan_WSP
Posts: 2
Registered: ‎01-17-2013
Message 1 of 2 (272 Views)

Pipe Support problem with sloped pipes P3D 2013

272 Views, 1 Replies
01-21-2013 12:13 AM

The pipe supports do not rotate and align to the pipe when I have a Sloped Pipe. Is it possible to change any settings in the program to make the pipe supports align with the pipe slope?

 

Problem with sloped pipes 2.JPG

Active Member
Sap_joakim
Posts: 7
Registered: ‎01-28-2013
Message 2 of 2 (200 Views)

Re: Pipe Support problem with sloped pipes P3D 2013

01-28-2013 10:34 PM in reply to: Stefan_WSP

I have the same problems. But you can rotate the support after attaching it to a pipe. this is what i have been doing on my sloep pipes. after you have rotated a support you just copy that one to youre next location using array with slope after pipe. remember to use Reference when you rotate the support sp you get it exactly right on the pipe :smileyhappy:

Good Luck

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Plant 3D Category!

The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.