AutoCAD Plant 3D General DIscussion

AutoCAD Plant 3D General DIscussion

Reply
Valued Contributor
57 Posts
3 Kudos
Registered: ‎12-16-2011
Post 1 of 2

Out of Spec item - leakage + 'open end' on iso

194 Views, 1 Replies
08-18-2012 10:00 AM

I have a filter with DIN flange, while the connecting piping is ANSI.

 

First I place the DIN flange to the equipment and then I place an CS150 elbow to the flange. The connection between the DIN flange and the ANSI elbow shows a leakage point + the isometric separates the ANSI line and the DIN flange into separate drawings showing 'open end' connections.

 

How can I force Plant3D to accept the connection, or alternativly; force the iso to show connecion + spec break?

 

Employee
566 Posts
52 Kudos
Registered: ‎12-01-2010
Post 2 of 2

Re: Out of Spec item - leakage + 'open end' on iso

08-19-2012 03:48 PM in reply to: vannmannen

Its probably missing a combination of the End Condition and the Schedule?

 

Check what these are on both and make them the same.



Tomislav Golubovic
Plant Solutions Engineer
Autodesk Australia / New Zealand
Autodesk, Inc.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Plant 3D Category!

The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Are you interested in helping shape the future of the Autodesk Community? To participate in this brief usability study, please click here. Your time and input is greatly appreciated!