AutoCAD Plant 3D General DIscussion

AutoCAD Plant 3D General DIscussion

Reply
Valued Contributor
vannmannen
Posts: 57
Registered: ‎12-16-2011
Message 1 of 2 (184 Views)

Out of Spec item - leakage + 'open end' on iso

184 Views, 1 Replies
08-18-2012 10:00 AM

I have a filter with DIN flange, while the connecting piping is ANSI.

 

First I place the DIN flange to the equipment and then I place an CS150 elbow to the flange. The connection between the DIN flange and the ANSI elbow shows a leakage point + the isometric separates the ANSI line and the DIN flange into separate drawings showing 'open end' connections.

 

How can I force Plant3D to accept the connection, or alternativly; force the iso to show connecion + spec break?

 

Employee
TomislavGolubovic
Posts: 542
Registered: ‎12-01-2010
Message 2 of 2 (155 Views)

Re: Out of Spec item - leakage + 'open end' on iso

08-19-2012 03:48 PM in reply to: vannmannen

Its probably missing a combination of the End Condition and the Schedule?

 

Check what these are on both and make them the same.



Tomislav Golubovic
Plant Solutions Engineer
Autodesk Australia / New Zealand
Autodesk, Inc.

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Plant 3D Category!

The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.