nipple display isometrics

[thebearjed]

on one project nipples are displayed as pipe on the isometrics. on another project they are displayed as a rectangle. i know there is a setting somewhere to change this but i can not remember where it was...any suggestions?

[PeterQuinn · Accepted solution]

I was just looking at this.

It's the Content Iso Symbol Definition. You probably changed it in the spec, but possibly in the catalog or the model itself. For double lines, use

TYPE=COUPLING,SKEY=NRSW        for SW ends

For single lines, looking like pipe, use

TYPE = PIPE

(no SKEY for pipe)

[thebearjed]

yes, thank you.