AutoCAD Plant 3D General DIscussion

AutoCAD Plant 3D General DIscussion

Reply
Valued Mentor
tmccar
Posts: 490
Registered: ‎11-28-2007
Message 1 of 1 (62 Views)

New port position not syncing

62 Views, 0 Replies
02-04-2013 10:11 AM

In Spec Editor, if I make changes to part numbers, end conditions and so on in the pcat, I can push these changes to the pipe spec by selecting "Synchronise Specs With Catalogs".

 However,if I change the position of a port on a part that was crested using PLANTPARTCONVERT, the new position does not get updated. Is there any solution/fix for this?

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Plant 3D Category!

The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.