I'm trying to get more options on the spec (SS150) than is offered. I want to use a 150lb, R.F. S.O. Flange, in a 4" sch. 40 size. Presently all I have available is a Weld Neck.
Little background. I'm presently evaluating Plant 3D to see if we should replace our present piping program (CADPipe) with Plant 3D, so this is my first time at using it, and since I'm not having much luck finding any tutorials, its becoming a pain to figure it out.
Any suggestions or help would be greatly appreciated.
Thanks in advance.
I can point you to some resources for learning Plant 3D.
The attached whitepaper is from Plant 2010 but will still give you a general understanding of how to use Spec & Catalog Editor.
This site has a full set of courseware with data sets to go along with the lessons (Autodesk Plant 3D 2012 Courseware Imperial & Mixed Metric)
Chapter 5 covers specs and catalogs:
The AutoCAD Plant 3D 2013 documentation:
For one-on-one training you can locate a Process Plant Specialized reseller in your area using this link:
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions to get help installing your software.
The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.
Upgrading to a 2015 product? Make sure to check these out 1st!