AutoCAD Plant 3D General DIscussion

AutoCAD Plant 3D General DIscussion

Valued Contributor
Posts: 65
Registered: ‎08-17-2011
Message 1 of 1 (108 Views)

Line Number to Automatically Change Spec and Service when Selected P3D 2012

108 Views, 0 Replies
04-27-2012 01:59 PM

We don't have pid's so we are going to setup a template drawing, place as many pieces of pipe as line #'s on our line list, and number the pieces of pipe 1 to 100.  We were going to export the data through data manager, change the line #'s, spec's, and service to match line list.  We then would import that information thorough data manager, automatically update the pieces of pipe and now we have a list of line #'s to choose from in any drawing we start.


We want to be able to select the line # from the line list and that would automatically update the spec and service so when you started to route piping, you would just have to change the size.


Does this make sense and is this possible?

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Plant 3D Category!

The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.