AutoCAD Plant 3D General DIscussion

AutoCAD Plant 3D General DIscussion

Reply
Valued Contributor
batone79
Posts: 68
Registered: ‎05-30-2006
Message 1 of 1 (266 Views)

Isometrics - Stub-In - split Mark acad Block

266 Views, 0 Replies
01-10-2013 01:25 AM

Hi to everyOne,

I got a problem making Isometrics, with Stub-In. in ACADP3D 2013

 

I got a Maniflod with a LineNumber, and this manifold has got some stub in with a LineNumber each one.

 

Isometric drawing use a Block Named Split Mark and this one some times is displayed on isoPlane an some times not, depend of Stub-In Pipe Status in 3D Drawing, Properties/General/Status.

 

Well, I will paste this two picture to give you graphic information.

 

02.jpg

 

01B.jpg


Can You Help me.??

 

Thanks..!!

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Plant 3D Category!

The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.