AutoCAD Plant 3D General DIscussion

AutoCAD Plant 3D General DIscussion

Reply
Active Contributor
Slepe
Posts: 42
Registered: ‎03-24-2011
Message 1 of 4 (867 Views)

Isometric doesn't show connection? Plant 3D 2013

867 Views, 3 Replies
11-02-2012 12:09 AM

I have problem with connection on isometric.

 

Isometric doesn't show any connection to other lines. It worked at the beginning but now it doesn't any work.

I also remake few lines and they worked little while and then connections disappeared??

 

 

Product Support
Dan.Scales
Posts: 305
Registered: ‎03-05-2010
Message 2 of 4 (801 Views)

Re: Isometric doesn't show connection? Plant 3D 2013

11-05-2012 07:39 AM in reply to: Slepe

Hi,

 

Make sure the "Show end connection annotation on Iso" is enabled for the Iso style being used and for the specific end connection type:

 

C:\Users\scalesd\Documents\~work\CONT_ON.png

 

I hope this helps.

 

Thanks,

Dan



Dan Scales
Active Contributor
Slepe
Posts: 42
Registered: ‎03-24-2011
Message 3 of 4 (789 Views)

Re: Isometric doesn't show connection? Plant 3D 2013

11-05-2012 10:08 PM in reply to: Slepe

I have checked these and there are OK.

 

When I make new line next to old ones it works just fine but the old ones doesn't.

 

I don't know if its possible to send my model to someone who can check it?

 

Member
MartinStotzer
Posts: 4
Registered: ‎04-14-2011
Message 4 of 4 (325 Views)

Re: Isometric doesn't show connection? Plant 3D 2013

11-25-2013 06:39 AM in reply to: Slepe

I have the same problem. No connections are showing, neither to sheet continuation nor drains. "Show end connection annotation on Iso" is checked.

 

When I change to a diffrent Iso styles it works fine but i want to use this one..

 

Any ideas?   

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Plant 3D Category!

The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.