I have a problem with one of my custom iso symbols (Reducing pipe insert). It works correctly most of the time, however, occasionally, it comes in 'mirrored'. I can't figure out why it works sometimes, and sometimes not..
I've tried switching the port locations, mirroring the graphics, switching the port locations AND mirroring the graphics. All to no avail. The insertion point and flanges seem to be correct, but the "insert" line has a mind of it's own.
Any help would be appreciated...
Heading down the road to Zantex...
Solved! Go to Solution.
Solved! by dave.wolfe. See the answer in context.
Look at the out of the box reducer symbol. It uses a Flip parameter to aid in orienting the reducer properly.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions to get help installing your software.
The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.
Upgrading to a 2015 product? Make sure to check these out 1st!