AutoCAD Plant 3D General DIscussion

AutoCAD Plant 3D General DIscussion

Reply
Distinguished Contributor
MOLGRAND
Posts: 114
Registered: ‎03-06-2008
Message 1 of 5 (454 Views)

ISO PROBLEMS - SPLIT POINT & DIM to POINT

454 Views, 4 Replies
09-01-2012 01:18 PM

Hi,

I'm having a little trouble in tweaking my Isos - when using the lap joint & spin flange they tend to break for continuation at the lap joint b/w & not on the gasket face. Also they seam to want to dimension to the lap joint b/w & not to the gasket face see attached PDF example.

Any helpers?

 

Regards

Gary

Product Support
Dan.Scales
Posts: 325
Registered: ‎03-05-2010
Message 2 of 5 (370 Views)

Re: ISO PROBLEMS - SPLIT POINT & DIM to POINT

10-04-2012 09:53 AM in reply to: MOLGRAND

Hi,

 

Do you have a small example project that you can provide for testing here?

 

Thanks,
Dan

 



Dan Scales
Distinguished Contributor
MOLGRAND
Posts: 114
Registered: ‎03-06-2008
Message 3 of 5 (366 Views)

Fwd: ISO PROBLEMS - SPLIT POINT - 1 of 2

10-04-2012 10:56 AM in reply to: Dan.Scales
Hi, See attached. I have attached one of the models from a large project, along with PDF files of the Isos I ran off & a PDF of the g/a which was print from the Otho drg produced. I hope you can help as it makes the ISO drgs difficult to work with - at the moment I have 3000 Isos! Regards Gary Randall
Product Support
Dan.Scales
Posts: 325
Registered: ‎03-05-2010
Message 4 of 5 (353 Views)

Re: ISO PROBLEMS - SPLIT POINT & DIM to POINT

10-05-2012 06:21 AM in reply to: MOLGRAND

Hi,

 

The drawing doesn't seem to have been uploaded.

Could you try again?

 

Thanks,
Dan



Dan Scales
Distinguished Contributor
MOLGRAND
Posts: 114
Registered: ‎03-06-2008
Message 5 of 5 (350 Views)

Re: ISO PROBLEMS - SPLIT POINT

10-05-2012 07:25 AM in reply to: Dan.Scales
Hi, Drg attached again Cheers
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Plant 3D Category!

The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.