AutoCAD Plant 3D General DIscussion

AutoCAD Plant 3D General DIscussion

Reply
Mentor
Ahmed1081975
Posts: 217
Registered: ‎09-29-2011
Message 1 of 5 (207 Views)

Incorrect elbow direction on isometric

207 Views, 4 Replies
03-31-2013 11:40 PM

Hi Autodesk Supports,

I have problem when generating the isometric for elbow welding

direct in another elbow, I don't know what is the problem is there

for more clarification refer the attached file

 

Regards,

 

Ahmed Helal

 

Product Support
gersteb
Posts: 166
Registered: ‎09-20-2010
Message 2 of 5 (151 Views)

Re: Incorrect elbow direction on isometric

04-04-2013 05:47 AM in reply to: Ahmed1081975

Dear Ahmed,

 

Please, can you send me the source drawing and your zipped iso-style. So I can look for it.

 

Regards

Bernd



Bernd Gerstenberger
Product Support
gersteb
Posts: 166
Registered: ‎09-20-2010
Message 3 of 5 (149 Views)

Re: Incorrect elbow direction on isometric

04-04-2013 05:48 AM in reply to: Ahmed1081975

Maybe you can send the source drawing to me directly.

 

Thanks

Bernd



Bernd Gerstenberger
Mentor
Ahmed1081975
Posts: 217
Registered: ‎09-29-2011
Message 4 of 5 (137 Views)

Re: Incorrect elbow direction on isometric

04-04-2013 12:40 PM in reply to: Ahmed1081975
Dear Bernd, Mail 1/2



PLs, find the attached file as your request



Regards,



Ahmed Helal


This e-mail message and any attachments to it are intended only for the named recipients and may contain confidential information. If you are not one of the intended recipients, please do not duplicate or forward this e-mail message and immediately delete it from your computer. If you received this e-mail by error, please notify postmaster@metito.com.

The sender does not accept any liability for any loss, of whatsoever nature, however caused in the context of this message, which may arise as a result of Internet transmission.
Distinguished Contributor
Arun_Kumar_K
Posts: 441
Registered: ‎06-03-2012
Message 5 of 5 (124 Views)

Re: Incorrect elbow direction on isometric

04-06-2013 08:23 PM in reply to: Ahmed1081975
Hi, Pls don't waste by researching about this. It's a bug in isometric engine, If you use welding gap in plant space, you ll find this issue. Reconnect all the pipe lines after deselecting the weld gap and generate isometric. Weld gap, slopes are only a eye wash in plant 3d space.
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Plant 3D Category!

The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.