I see that after inserting the hanger support on the pipe, if I want to copy o move, after press part move grip the support is rotated automatically to horizontal position... Why? It's happen only with hangger supports...
have same problem !! [plant 3d 2013 with service pack 2]
Hanger rotation defaults to horizontal orientation when copied or moved
for beam clamp hangers CSGH003 004 005 006 (and 001 002
007 008 009 are not affected by problem - behave as should
this is not the case in video... at 4:05
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions to get help installing your software.
The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.
Upgrading to a 2015 product? Make sure to check these out 1st!