Fitting connected to equipment say they are open ends in ISO's

[Vitornis]

Any where i have a fitting connected directed to a piece of equipment, when i generate a ISO it always says these are open ended. See the link below. https://www.evernote.com/shard/s162/sh/d4df367b-221f-4d6e-8d64-0edcf0665dbd/55527f18313d3bb5e5f031bb...

[milic.srdjan]

Halo,

On picture, ISO picture, I do not see gaskets.
Only flanges [F] and bolts {B].
I think that will be good to export and post PCF file for the line.
Also I do not see spacer fitting on ISOs

Srdjan

[Vitornis]

This is lined pipe and i don't have any gaskets.

[richard.imrie]

We havesame issue here. you'll be using FLL end type? Autodesk advised us that a 'custom' end type may be causing the issue.

If you use a normal flange does it connect to equipment without errors?

[Vitornis]

Im using the OOB LFL and LPL Lined FLange and Lap Lined.