AutoCAD Plant 3D Forum
Welcome to Autodesk’s AutoCAD Plant 3D Forums. Share your knowledge, ask questions, and explore popular AutoCAD Plant 3D topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Creating/Duplicate new flange

3 REPLIES 3
Reply
Message 1 of 4
PHammink8001
439 Views, 3 Replies

Creating/Duplicate new flange

For a project we need a DIN 2576 flange, this flange isn't in the catalog, zo I created one.
I used the Din 2642 LAP flange to duplicate and changed it into a DIN 2576 flange, whit al the correct dimensions and end types.
When I wanted to change the facing, I noticed that the box whit the facing type coudn't be changed.
Also the Engadment length coudn't be changed,
Then I changed the value in the advanced editing tabel but this didn't work either.

Are there any solutions for these problems?

With Regards,

Hans Golbach,
Primat
3 REPLIES 3
Message 2 of 4
RSFAdsk
in reply to: PHammink8001

Hello Hans,

Did you clear the Part Geometry properties... permission checkbox?
Some port properties are protected along with dimensions. I am able to set those values after clearing that checkbox.

Rich Frank, Autodesk


Richard Frank
Autodesk Knowledge Network
Autodesk, Inc.
Message 3 of 4
PHammink8001
in reply to: PHammink8001

Hello Rich,

Where can I find this "Part Geometry properties...permission checkbox"?
I look for this in the Catalog editor.
(working in the Beta Plant3D 2011 now)

With Regards,

Henk Segveld
Primat Projectservice
Message 4 of 4
RSFAdsk
in reply to: PHammink8001

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report

”Boost