AutoCAD Plant 3D General DIscussion

AutoCAD Plant 3D General DIscussion

Reply
Active Contributor
PHammink8001
Posts: 49
Registered: ‎10-21-2009
Message 1 of 4 (209 Views)

Creating/Duplicate new flange

209 Views, 3 Replies
02-26-2010 02:47 AM
For a project we need a DIN 2576 flange, this flange isn't in the catalog, zo I created one.
I used the Din 2642 LAP flange to duplicate and changed it into a DIN 2576 flange, whit al the correct dimensions and end types.
When I wanted to change the facing, I noticed that the box whit the facing type coudn't be changed.
Also the Engadment length coudn't be changed,
Then I changed the value in the advanced editing tabel but this didn't work either.

Are there any solutions for these problems?

With Regards,

Hans Golbach,
Primat
Employee
RSFAdsk
Posts: 172
Registered: ‎02-27-2009
Message 2 of 4 (209 Views)

Re: Creating/Duplicate new flange

02-26-2010 01:07 PM in reply to: PHammink8001
Hello Hans,

Did you clear the Part Geometry properties... permission checkbox?
Some port properties are protected along with dimensions. I am able to set those values after clearing that checkbox.

Rich Frank, Autodesk


Richard Frank
AEC Plant Solutions
Autodesk, Inc.
Active Contributor
PHammink8001
Posts: 49
Registered: ‎10-21-2009
Message 3 of 4 (209 Views)

Re: Creating/Duplicate new flange

03-01-2010 06:52 AM in reply to: PHammink8001
Hello Rich,

Where can I find this "Part Geometry properties...permission checkbox"?
I look for this in the Catalog editor.
(working in the Beta Plant3D 2011 now)

With Regards,

Henk Segveld
Primat Projectservice
Employee
RSFAdsk
Posts: 172
Registered: ‎02-27-2009
Message 4 of 4 (209 Views)

Re: Creating/Duplicate new flange

03-01-2010 11:44 AM in reply to: PHammink8001
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Plant 3D Category!

The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.