I just want to know if there is a way of creating ortho section views in say NE or NW, SW or SE direction.
Rotate the model 45 deg is the only way I think.
The work flow I have used here on many cases is to set up some "dummy" models and xref the models you require. Then rotate the entire set of objects to where you want it. This file is not to be used for design, nothing would connect to the ports at all.
Then when running your Ortho, use the "Dummy" model.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions to get help installing your software.
The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.
Upgrading to a 2015 product? Make sure to check these out 1st!