AutoCAD Plant 3D General DIscussion

AutoCAD Plant 3D General DIscussion

Reply
Member
Lars_Petersson
Posts: 5
Registered: ‎02-06-2012
Message 1 of 3 (167 Views)
Accepted Solution

Correlation between port numbers in custom geometry.

167 Views, 2 Replies
05-21-2012 12:32 AM

Hi all.

 

Can anyone tell me if there is a correlation between port number and the order in which you add ports for custom geometries using PLANTPARTCONVERT command?

 

Does the first created port always get number 1? Or is it controlled somehow in spec editor?

 

Thanks

Correct!

The port numbers in the spec editor are the port center points what you selected after the PLANTPARTCONVERT.

So the first selected point will be the port 1, the second will be the port 2 and etc...

Mentor
attila_vallyon
Posts: 256
Registered: ‎11-03-2009
Message 2 of 3 (163 Views)

Re: Correlation between port numbers in custom geometry.

05-21-2012 03:14 AM in reply to: Lars_Petersson

Correct!

The port numbers in the spec editor are the port center points what you selected after the PLANTPARTCONVERT.

So the first selected point will be the port 1, the second will be the port 2 and etc...

Regards,
Attila Vallyon
Member
Lars_Petersson
Posts: 5
Registered: ‎02-06-2012
Message 3 of 3 (156 Views)

Re: Correlation between port numbers in custom geometry.

05-21-2012 04:37 AM in reply to: attila_vallyon

Great!

 

Thanks Attila

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Plant 3D Category!

The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.