AutoCAD Plant 3D General DIscussion

AutoCAD Plant 3D General DIscussion

Valued Mentor
Posts: 460
Registered: ‎04-08-2010
Message 1 of 2 (123 Views)
Accepted Solution

Changing the insertion point of an ortho view? ( create ortho view )

123 Views, 1 Replies
01-29-2013 11:05 AM

Is there a command to change the insertion point of an ortho?


currently it defaults to the bottom left corner, I want to change it to the center.


I place the ortho down then select the mid between two points to replace each and every ortho I place, which is a lot of wasted time.



An education isn't how much you have committed to memory, or even how much you know. It's being able to differentiate between what you know and what you don't.
"Do or do not... there is no try"
Master Yoda.
Product Support
Posts: 298
Registered: ‎03-05-2010
Message 2 of 2 (85 Views)

Re: Changing the insertion point of an ortho view? ( create ortho view )

02-01-2013 04:11 AM in reply to: JohnHolder



It is not possible to change the default insertion point of the ortho viewport from the bottom left point.


You can post a feature enhancement request here:


Product Feedback







Dan Scales
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Plant 3D Category!

The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.