AutoCAD Plant 3D General DIscussion

AutoCAD Plant 3D General DIscussion

Reply
Valued Mentor
ybogdanov
Posts: 385
Registered: ‎07-07-2011
Message 1 of 2 (388 Views)

AutoFlange with DIN flange and ASME pipe

388 Views, 1 Replies
10-01-2012 08:06 AM

Hello,

 when I use mixed spec, where pipes are ASME and flanges DIN. I allow all mixed connections. And when I want to connect BV end of DIN flange with PL end of ASME pipe it's connected ok. But the problem is in the AutoFlange connection. Because in this case it's not connected.

Any solution?

Thanks

-----------------------------------------------------------
Yury Bogdanov
ASIDEK(Grupo CT) - Partner Directo de Autodesk
Barcelona (Spain)
Valued Mentor
ybogdanov
Posts: 385
Registered: ‎07-07-2011
Message 2 of 2 (388 Views)

Re: AutoFlange with DIN flange and ASME pipe

10-01-2012 08:37 AM in reply to: ybogdanov

The solution is to modificate Connection xml file on the project.

 

-----------------------------------------------------------
Yury Bogdanov
ASIDEK(Grupo CT) - Partner Directo de Autodesk
Barcelona (Spain)
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Plant 3D Category!

The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.