AutoCAD Plant 3D General DIscussion

AutoCAD Plant 3D General DIscussion

Reply
Valued Contributor
blorich
Posts: 89
Registered: ‎08-01-2007
Message 1 of 2 (414 Views)

AUTO Flange

414 Views, 1 Replies
11-29-2012 12:21 PM

So for my current project my AUTO Flange isn't working.  I checked the default project(which I made no changes to) and it works.  I checked my compund joints and its setup correctly idecitcal to the default project.  For the simple joints the only thing I had to change was allowing 125lb flanges to connect to 150.  Would that be the reason why It wont auto flange?

 

I am also using a custom spec, which has flanges, gaskets and bolts, because I can place them in seperatly and they will connect.  

 

SOLVED see next post, new question there!

Valued Contributor
blorich
Posts: 89
Registered: ‎08-01-2007
Message 2 of 2 (414 Views)

Re: AUTO Flange

11-29-2012 12:37 PM in reply to: blorich

I solved my own problem, it was the fact that the valve was a 125lb with a 150 lb flange, I have over come this by removing the requirement for a pressure class at the moment.   Although i find it weird that the Compund joint was not grabing the information from the simple joint that allows me to add a 150lb flange to a 125 valve.

 

 

NEW question, while im routing pipe and i hit "f" for fitting and I add an elbow, then I want to add a flange to that elbow, it auto throws a 1" long peice of pipe inbetween the elbow and the flange, and I dont want it, how can I make that stop?

 

SOLVED my gosh i jst need to look harder lol, now im just talking to myself.  Just below is the Pipe segments where it says 1".

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Plant 3D Category!

The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.