AutoCAD Plant 3D General DIscussion

AutoCAD Plant 3D General DIscussion

Reply
Contributor
samsonthomas7606
Posts: 16
Registered: ‎09-15-2010
Message 1 of 3 (389 Views)

3R ELBOW CREATION IN SPEC AND ISOMETRIC REPRESENATIONS

389 Views, 2 Replies
11-21-2012 04:48 PM

Hello

I used PLANTPARTCONVERT to creat new fitting 3R 45 ELBOW and added it to our spec. When i have generated the ISOMETRIC angle shown is 43. See attached pics. Is there anything that I am doing wrong?

 

 

Using Plant3d 2012

 

Thanks for any help or pointers

 

Samson Thomas

 

Product Support
Dan.Scales
Posts: 325
Registered: ‎03-05-2010
Message 2 of 3 (336 Views)

Re: 3R ELBOW CREATION IN SPEC AND ISOMETRIC REPRESENATIONS

11-23-2012 03:35 AM in reply to: samsonthomas7606

Hi,

 

Do you have cutback elbows enabled?

 

If you select the elbow and open the Properties Palette you can check under "Part Geometry" to see if a cutback angle has been applied to the elbow.

 

Thanks,

Dan



Dan Scales
Contributor
samsonthomas7606
Posts: 16
Registered: ‎09-15-2010
Message 3 of 3 (239 Views)

Re: 3R ELBOW CREATION IN SPEC AND ISOMETRIC REPRESENATIONS

11-30-2012 09:55 AM in reply to: Dan.Scales

Hello Dan,

Thanks for the reply. I tried with cutback elbows disabled. I still did not work properly. I created a brand new project and this new spec worked just fine.

 

Thanks for your reply.

 

Samson

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Plant 3D Category!

The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.