AutoCAD Plant 3D General DIscussion

AutoCAD Plant 3D General DIscussion

Reply
Contributor
16 Posts
0 Kudos
Registered: ‎09-15-2010
Post 1 of 3

3R ELBOW CREATION IN SPEC AND ISOMETRIC REPRESENATIONS

395 Views, 2 Replies
11-21-2012 04:48 PM

Hello

I used PLANTPARTCONVERT to creat new fitting 3R 45 ELBOW and added it to our spec. When i have generated the ISOMETRIC angle shown is 43. See attached pics. Is there anything that I am doing wrong?

 

 

Using Plant3d 2012

 

Thanks for any help or pointers

 

Samson Thomas

 

Product Support
326 Posts
35 Kudos
Registered: ‎03-05-2010
Post 2 of 3

Re: 3R ELBOW CREATION IN SPEC AND ISOMETRIC REPRESENATIONS

11-23-2012 03:35 AM in reply to: samsonthomas7606

Hi,

 

Do you have cutback elbows enabled?

 

If you select the elbow and open the Properties Palette you can check under "Part Geometry" to see if a cutback angle has been applied to the elbow.

 

Thanks,

Dan



Dan Scales
Contributor
16 Posts
0 Kudos
Registered: ‎09-15-2010
Post 3 of 3

Re: 3R ELBOW CREATION IN SPEC AND ISOMETRIC REPRESENATIONS

11-30-2012 09:55 AM in reply to: Dan.Scales

Hello Dan,

Thanks for the reply. I tried with cutback elbows disabled. I still did not work properly. I created a brand new project and this new spec worked just fine.

 

Thanks for your reply.

 

Samson

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Plant 3D Category!

The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Are you interested in helping shape the future of the Autodesk Community? To participate in this brief usability study, please click here. Your time and input is greatly appreciated!