I have two Line Nos. which are connected, looking to take the both the line nos. in one drawing, using production iso, i could only generate one iso for one line no., only by using quick iso i can take this by isolating the two line numbers, however the line no. is not getting displayed. Is there anyway in production iso to take two line number in one drawing. If not possible, request Autodesk to take this as a wish list, as this is highly imperative.
Try unchecking the Line no in the advance setting while generating iso.
My apologies yeah right in production ISO there is no such option.
But I am wondering why would you want two line nos in the same production ISO?
Say for example, I have three pumps, discharge line of the three pumps are connected to the header, from the header the line goes to condenser.
As all the pipe sizes are different, here i need to specify three pump discharge lines as three different line nos, like header one line number and header to condenser another line no.
If you see the routing of all it will be very simple, like a straight line. For this I shouldn't take 5 different Isometrics. If there is a provision in the software, I can take this all in one drawing.
Presently I tried to use Quick Iso, but its not displaying line no evethough I specified the line nos. Only in Production iso, the line no. is diplaying but generates only line wise.
Please take this has a wishlist, the software should have option to select the required line nos to generate the isometric combinedly.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions to get help installing your software.
The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.
Upgrading to a 2015 product? Make sure to check these out 1st!