AutoCAD P&ID General Discussion

AutoCAD P&ID General Discussion

Reply
Valued Contributor
Heckmeck
Posts: 57
Registered: ‎10-10-2011
Message 1 of 2 (409 Views)

Table changes format

409 Views, 1 Replies
04-24-2012 12:41 AM

Hi Everyone!

 

I have a problem with the tables on my drawing.

I use an excel sheet to change certain cells in the tables.

In AcadPID I get the message to update the table on my drawing.

 

Now, the content of the cell is updated properly, but everytime, the dimensions of my table change completey.

I have set the table in AcadPID to "Format Locked" but still my table changes.

 

What can I do here?

 

Thanks and best regards!

Valued Contributor
Heckmeck
Posts: 57
Registered: ‎10-10-2011
Message 2 of 2 (291 Views)

Re: Table changes format

10-25-2012 02:43 AM in reply to: Heckmeck

Is there no one who has the same problem?

 

I would appreciate, If some of the developers here could try it out, to see if it is a general problem.

 

Thanks in advance!

 

Edit:  Deleted all existing tables and their connections, set up everything again, now it's working as it should!

 

Think it happens if you replace exisiting data connections.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD P&ID Category!

The AutoCAD P&ID forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.