AutoCAD P&ID General Discussion

AutoCAD P&ID General Discussion

Reply
Valued Contributor
Grampster
Posts: 81
Registered: ‎01-11-2012
Message 1 of 1 (128 Views)

Relief valves operator won't orient with valve discharge downward

128 Views, 0 Replies
05-20-2012 06:52 PM

Occasionally, you need to place a relief valve with the inlet horizontal and the discharge downward (i.e. to open drain). Draw a horizontal primary line, then turn downward. Now try to insert the relief valve. It will insert with the inlet coming from the downward line; the operator is oriented wrong. The work-around is to draw the primary line up, then horizontal, place the valve, rotate lines and valves, then move the results to where needed. Not exactly convenient. How can I correct the situation?

Sunetic Services
Owner/Consultant
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD P&ID Category!

The AutoCAD P&ID forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!