AutoCAD P&ID General Discussion

AutoCAD P&ID General Discussion

Posts: 4
Registered: ‎11-10-2001
Message 1 of 2 (129 Views)

Reducer flip problem

129 Views, 1 Replies
06-03-2008 08:21 PM
In some occasions reducers don't have the flip option available.
(I am using SQLexpress project setting)
Valued Contributor
Posts: 61
Registered: ‎04-25-2007
Message 2 of 2 (129 Views)

Re: Reducer flip problem

06-03-2008 10:10 PM in reply to: meir_w
I too have seen that in testing, but very little. I usually notice it when the hard drive seems to try to page or something right after selecting the reducer. It may be just a coincidence to me but using a laptop most of the time and by happenstance seeing the hard drive light come on while waiting for the reverse arrow to appear seems to be related.

If that is so, then there is a lag in the query of the part selection.

Just an observation.....

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD P&ID Category!

The AutoCAD P&ID forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.