AutoCAD P&ID General Discussion

AutoCAD P&ID General Discussion

Reply
Contributor
aeiken
Posts: 20
Registered: ‎08-19-2008
Message 11 of 14 (275 Views)

Re: Publish always fails

09-11-2012 07:11 AM in reply to: aeiken

Hi Dan,

 

I started looking at the system variables for AutCAD P&ID 2013 for publishing. I tried setting PUBLISHCOLLATE to 0 instead of the initial value of 1. That seems to have done the trick. I've been able to publish using the same old page setups that I've been trying since AutoCAD P&ID 2013 was installed. All sheets publish without errors. Publish seems to fail after the first drawing when PUBLISHCOLLATE is set to 1.

 

Ken

Product Support
Dan.Scales
Posts: 318
Registered: ‎03-05-2010
Message 12 of 14 (274 Views)

Re: Publish always fails

09-11-2012 07:26 AM in reply to: aeiken

Hi Ken,

 

Good find.

 

I'll test this and log it with our developers.

 

Thanks,
Dan



Dan Scales
Product Support
Dan.Scales
Posts: 318
Registered: ‎03-05-2010
Message 13 of 14 (268 Views)

Re: Publish always fails

09-11-2012 08:43 AM in reply to: Dan.Scales

Hi Ken,

 

I can't get the publish command to fail on my machine here.

 

I tested with PUBLISHCOLLATE and BACKGROUNDPLOT set to various configurations and I always get all drawings published.

 

Anyway, I am glad your issue with plotting was fixed with the PUBLISHCOLLATE variable.

 

Thanks,

Dan



Dan Scales
Contributor
aeiken
Posts: 20
Registered: ‎08-19-2008
Message 14 of 14 (261 Views)

Re: Publish always fails

09-12-2012 04:05 AM in reply to: aeiken
Hi Dan, BACKGROUNDPLOT was already set to 0. Ken Miller Instrumentation and Controls AEI | AFFILIATED ENGINEERS, INC. 5802 Research Park Boulevard | Madison, WI 53719 P: 608.441.6665 | F: 608.238.2614 kmiller@aeieng.com | www.aeieng.com
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD P&ID Category!

The AutoCAD P&ID forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!