AutoCAD P&ID General Discussion

AutoCAD P&ID General Discussion

Reply
Distinguished Contributor
phil.cooper
Posts: 120
Registered: ‎11-29-2012
Message 1 of 1 (285 Views)

Off page connectors not showing to and from correctly

285 Views, 0 Replies
12-06-2012 06:33 AM

I have set up my off page connectors to show the drawing they are going to/coming from. However they actually show the drawing number of the drawing that they are on.

 

The connector on PID001 shows its going to PID001 and the connector on PID002 shows its coming from PID002.

 

any ideas?

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD P&ID Category!

The AutoCAD P&ID forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.