AutoCAD P&ID General Discussion

AutoCAD P&ID General Discussion

Reply
Distinguished Contributor
Thomas.Rambach
Posts: 572
Registered: ‎07-22-2004
Message 1 of 2 (340 Views)

Odd behavior

340 Views, 1 Replies
03-20-2007 12:17 PM
If you make a "L" shaped pipe leg and want to switch the direction of the L, how can you do this?
*Jorge Lopez
Message 2 of 2 (339 Views)

Re: Odd behavior

03-20-2007 04:01 PM in reply to: Thomas.Rambach
You can mirror the leg. Are you trying to use the extend grip to move it? If
so, that will not work because it attempts to extend the line instead of
changing the position of the last vertex.

We are improving this behavior to determine intent when using the extend
grip to shorten or in this case change the direction of the last segment. In
the initial release, if I recall correctly, you can change the VGRIPS
variable temporarily to change the behavior of the extend grip. This will
not be needed in future version.



"TRambach" wrote in message news:5524907@discussion.autodesk.com...
If you make a "L" shaped pipe leg and want to switch the direction of the L,
how can you do this?
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD P&ID Category!

The AutoCAD P&ID forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.