I have a horizontal and a vertical line. There is a line break if the lines have a different break priority.
When I substitute the line with the higher priority with a line class having the same or lower priority so there will be no more an automatic line break.
How can I fix this?
It works fine on my site. Here is a link for a video to show you how it works here. If you see something different from your procedure, please, tell me. What happens if you have a new project with a new drawing. Do you see the same issue there? What happens if you add a new drawing to your old project? The same here?
it is the same behavior when creating a new drawing in the old project.
it is the same behavior when creating a new drawing in a new project, created from our master project.
it is the same behavior when creating a new drawing in a new project.
Do you use gaps or loops for the line crossing style? What is the value of the gap/loop width? What happens if you do a REGENALL?
I use gaps with 5 mm width. REGENALL doesn't help.
(When I move one of the lines the break will be inserted again.)
Thanks for the information here. I can now recreate the issue when I use PIP norm, creating two crossing primary line segments and after substituting one of them with 'secondary line segment - existing' the gap is lost. I logged this now to our developemnt department. The workaround here is to substitute it with 'secondary line segment' and afterwards to 'secondary line segment - existing' back again. Then you will see the gap on the right place.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions to get help installing your software.
The AutoCAD P&ID forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.
Upgrading to a 2015 product? Make sure to check these out 1st!