AutoCAD P&ID General Discussion

AutoCAD P&ID General Discussion

Reply
Contributor
rnishimura
Posts: 19
Registered: ‎07-13-2007
Message 1 of 4 (635 Views)

New ISA5.1 Standards in AutoCad P&ID 2009?

635 Views, 3 Replies
02-22-2010 05:53 PM
Is there an updated for AutoCad P&ID 2009 with the new ISA5.1 standards from last year?

http://www.isa.org/InTechTemplate.cfm?Section=Standards_Update1&template=/ContentManagement/ContentDisplay.cfm&ContentID=79003

If not, I am assuming AutoCad P&ID 2010 does not have this update either, but will these updates be available in AutoCad P&ID 2011?

Thanks,
Ryan
*Peter Quinn
Message 2 of 4 (635 Views)

Re: New ISA5.1 Standards in AutoCad P&ID 2009?

02-23-2010 09:28 AM in reply to: rnishimura
Ryan,

We haven't updated the delivered symbols in AutoCAD P&ID 2010. I will
investigate and see when the changes can be incorporated into our roadmap.
If there is sufficient demand, new symbols can be made available via the web
outside of the usual release cycle.

Peter Quinn (Autodesk)

wrote in message news:6342016@discussion.autodesk.com...
Is there an updated for AutoCad P&ID 2009 with the new ISA5.1 standards from
last year?

http://www.isa.org/InTechTemplate.cfm?Section=Standards_Update1&template=/ContentManagement/ContentDisplay.cfm&ContentID=79003

If not, I am assuming AutoCad P&ID 2010 does not have this update either,
but will these updates be available in AutoCad P&ID 2011?

Thanks,
Ryan
Valued Contributor
Arthur_Dent
Posts: 83
Registered: ‎06-13-2008
Message 3 of 4 (635 Views)

Re: New ISA5.1 Standards in AutoCad P&ID 2009?

03-02-2010 12:39 PM in reply to: rnishimura
This is something that I'd be looking for, too.

Thanks
Member
nasom
Posts: 3
Registered: ‎05-19-2010
Message 4 of 4 (601 Views)

Re: New ISA5.1 Standards in AutoCad P&ID 2009?

08-13-2010 09:26 AM in reply to: Arthur_Dent

This is one of the reasons i bought P&ID. So i would not have to create all the new symbols. I'm very interested in doing this.

 

At a minimum, Autodesk should show how to make the new ISA symbols. This would make it semi-standard.

 

Matt

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD P&ID Category!

The AutoCAD P&ID forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.