AutoCAD P&ID General Discussion

AutoCAD P&ID General Discussion

Reply
Valued Contributor
hinde
Posts: 83
Registered: ‎03-26-2007
Message 1 of 3 (144 Views)

Information disappears

144 Views, 2 Replies
02-19-2008 08:30 AM
I added an vessel info tag to the driers i created. I added the information (width and height, pressure and temperature) to the tag block. When i close the drawing and re-open it, the information disappears. I am confused?

Eric
*Jorge Lopez
Message 2 of 3 (144 Views)

Re: Information disappears

02-19-2008 12:24 PM in reply to: hinde
Hi Eric,

Can you provide the steps you followed? I am particularly interested in what
you mean by "added information to the tag block." Do you mean the Tag Assign
dialog that fills properties in the corresponding row shown in the Data
Manager?

Thanks,

Jorge

"Hinde" wrote in message news:5852093@discussion.autodesk.com...
I added an vessel info tag to the driers i created. I added the information
(width and height, pressure and temperature) to the tag block. When i close
the drawing and re-open it, the information disappears. I am confused?

Eric
Valued Contributor
hinde
Posts: 83
Registered: ‎03-26-2007
Message 3 of 3 (144 Views)

Re: Information disappears

02-21-2008 08:25 AM in reply to: hinde
I created two blocks to become driers. The driers did not have their own information tag so i copied the Vessel InfoTag_block to use as the Drier Information_block. I inserted the needed information into the drawing for the two driers. Everything looked good but when i close out and re-open the drawing the information for the two driers disappears.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD P&ID Category!

The AutoCAD P&ID forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!