AutoCAD P&ID General Discussion

AutoCAD P&ID General Discussion

Active Member
9 Posts
1 Kudo
Registered: ‎11-04-2011
Post 1 of 2

Breaking PID lines.

276 Views, 1 Replies
07-09-2012 12:23 PM

Most likely this question was raised million times, but I could not find the answer.

Is there a way (lisp or technic) that will break automatically intersecting lines, with an option for me to specify distance?

Should work on plain lines and on polylines.


564 Posts
51 Kudos
Registered: ‎12-01-2010
Post 2 of 2

Re: Breaking PID lines.

07-09-2012 04:45 PM in reply to: kmankov

P&ID already does this, the option to specify the distance is in the project properties.

Tomislav Golubovic
Plant Solutions Engineer
Autodesk Australia / New Zealand
Autodesk, Inc.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD P&ID Category!

The AutoCAD P&ID forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.