AutoCAD P&ID General Discussion

AutoCAD P&ID General Discussion

New Member
Posts: 1
Registered: ‎01-21-2013
Message 1 of 2 (439 Views)

Autogenerate loop numbers based on area

439 Views, 1 Replies
01-21-2013 03:55 PM

Is there a way to autogenerate the loop number based on the area?  The scenerio is this.  We have a

plant with multiple areas and would like loop numbers to restart when I change areas.  Tags would look

like 100-FE-001 for a 100 area and 200-FE-001 for a 200 area.

Valued Contributor
Posts: 81
Registered: ‎10-31-2011
Message 2 of 2 (407 Views)

Re: Autogenerate loop numbers based on area

01-22-2013 11:11 AM in reply to: bspiker725

You can assign a drawing property and refrence that within the tag.  If you have multiple areas per drawing it will become much harder, but not impossible.  If you are already creating area breaks like spec breaks, then a line property can be had with an aquisition from the line itself.  It would help greatly to know if you plan on having more than one area per drawing or not.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD P&ID Category!

The AutoCAD P&ID forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.