AutoCAD MEP Wishes

Reply
Active Contributor
chansen
Posts: 27
Registered: ‎10-01-2003
Message 11 of 12 (31 Views)

Re: Multiple Scales

12-31-2003 12:46 PM in reply to: *Andrew
The work arounds mentioned in the replies do not work if you are using the exact same drawing area for your 1/8" viewport and 1/4" viewport (layer visibility controls what is shown in each viewport). I would like to have the ability to control the scale of the symbols as well as the annotation based upon the viewport (similar to ltscale/psltscale).
Active Contributor
chansen
Posts: 27
Registered: ‎10-01-2003
Message 12 of 12 (31 Views)

Re: Multiple Scales

12-31-2003 12:56 PM in reply to: *Andrew
oops I finally got the suggestion to scale the xref to work - however it REALLY bogged down the regeneration time of the drawing. I still wish for an easier (and faster) work around! Thanks
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.